Murphyslaw.

This is the beginning of my project, it is a 91' Blazer.

It is undergoing an SFA conversion with a high pinion reverse-cut Dana 44, the rear axle is a Ford 9".

The wheelbase is being extended by about 8", because the wheelwells cannot be opened up evenly without cutting into the cab.

Currently the motor/trans/trans case is stock, and depending on how long it holds together, it will be swapped for a 350 or a diesel motor (preferable).

The tires are 38.5 x 15 x 16 Boggers.

You can see the aft frame extensions in place. They are being roughed in first to locate the front end off of. The rear springs will be the stock leaf setup, the front is a full size Bronco leaf setup, both are being rearched 6" and all 8 hangars and mounts are being relocated.

The end result will be 3" body lift, 6" spring lift, app 4" frame mount-fab lift, 10" tire lift.